Scope RS232 Bedienungsanleitung PDF herunterladen (Seite 3)

Get access to a rich set of integrated protocol level triggers. The application

includes a suite of configurable protocol-level trigger conditions specific to

RS-232/UART. The application uses software-based search triggering when

serial triggering is selected.

With software-based protocol triggering, the oscilloscope takes signals acquired

using either scope or digital channels and reconstructs protocol frames after

each acquisition. It then inspects these protocol frames against specified

protocol-level trigger conditions and triggers when the condition is met.

RS-232/UART setup and triggering

Baud rate settings

Enter any baud rate between

1,200 kb/s and 10 Mb/s, or click on

up/down arrows to go to one of many

pre-defined common baud rates.

Payload editor

Choose trigger length between one to

27 words and use the payload editor

to specify data values word by word.

Set trigger

Enter trigger condition in HEX, binary,

decimal or ASCII.

RS-232 Trigger Setup

Quickly access protocol triggering via

the scope’s trigger menu. Choose Tx

or Rx and specify RS-232 trigger in

HEX, binary decimal, or ASCII up to

27 words.

1 2 3 4 5 6 7 8

Keine Kommentare

Scope RS232 Bedienungsanleitung Seite 3